First time ruined!

Mah'dee Daye · Post by **Mah'dee Daye** » Thu Jun 22, 2006 12:31 pm

I just logged in as my character and was approached by a gnome who was able to introduce themselves as Xandjik. Everything was going well until I tried to use the #i command and nothing happened!

I thought maybe I had read the guide wrong so I tried to get back to the guide. I waited so long that it caused the poor gnome to get frustrated. I tried to respond by typing out my name in the greeting, knowing it would be better not to break character.

It was too late however and my first attempt at roleplaying here was an utter failure!

I finally found the guide and it says to use the #i command! Why doesn't it work for me?

Alkuurg · Post by **Alkuurg** » Thu Jun 22, 2006 12:36 pm

Typing #i gives your name to the other person only if they are at most 2 squares vertical or horizontally or 1 square diagnolly away. However, once you press it, it wont change anything on your screen, only the other players.

Thariel Feuersturm · Post by **Thariel Feuersturm** » Thu Jun 22, 2006 12:46 pm

sorry, my failure, i received your name, but i was wondering, why you wasnt introducing youself and waiting for a introduction. I dindt know, that you are new. you played well.

Mah'dee Daye · Post by **Mah'dee Daye** » Thu Jun 22, 2006 12:50 pm

Thank you. I am glad that you read this so we could clear that up.

Keikan Hiru · Post by **Keikan Hiru** » Thu Jun 22, 2006 12:57 pm

In other words:

When you use "#i", the other player still expects from your character to say something like: "Well met, my name is ... "

Mah'dee Daye · Post by **Mah'dee Daye** » Thu Jun 22, 2006 1:09 pm

Got it. You all are very helpful. Thank you.